DIY SANDING

Staining timber can bring out the natural color, feel and feed of the timber. Discoloration can improve the beauty of old furnishings in the house and give the entire room a new take on life. Discoloration is the last stage that gives the furnishings its new look. Before this is done the furnishings has to be prepared to receive the dirt and this procedure is called sanding.

Though time intensive it is an essential step in staining. Here are a few suggestions to help you through the sanding procedure.

Sandpaper is evaluated based on the variety of excellent sand granules per sq. inches of document. The greater the variety the locater the standard of document. Smaller quality variety, rougher the excellent sand document. This variety is usually printed behind the document. Method quality document is used to remove the current complete from furnishings and collectibles. Fine evaluated document is for the last sanding of furnishings just before staining the timber.

For sensitive furnishings and a excellent complete it is best to use hand sanding. Make excellent sand document pieces that are large enough to keep with three fingertips. If you find it more comfortable cover a piece of excellent sand document around a avoid of timber that you can keep with ease. Or you could use a curved sanding avoid that is easily available in the shop. This avoid has lines at the ends of the avoid into which you can inset the excellent sand document. Examine the outer lining area of the timber to be worked on, you will see pores that form a design, this is the feed of the timber.

Sand in the direction of the feed never against it. Sanding against the feed will cause scrapes that will show up on finished timber especially after staining.Place the sanding avoid flat in a trench on the outer lining area with the feed of timber.


Hold the avoid strongly and implement stress similarly as you move the avoid too and froe. If you implement more stress than needed the avoid it will cause downturns on the outer lining area. Even while using the technical hand sander, a lightweight-rotating sander, keep it flat against the outer lining area and similarly implement stress.

Before staining the timber dirt must be taken off the outer lining area. Use equipment fabric or cheesecloth made for eliminating dirt. Once one part of the fabric gets dirty, refold and use fresh part of fabric. To avoid equipment fabrics from dehydrating shop them in plastic bags that can be enclosed. As you will be workingwith timber dirt use a sanding compound cover up to avoid breathing of dirt.

Tweet